Surface prep
Cleaning and rust treatment so the coating bonds properly.
A roofer in Haledon can apply a liquid roof coating, usually silicone or acrylic, over a flat, low-slope or metal roof that is weathered but still dry and structurally sound, and a moisture check comes first, because coating over wet insulation traps the problem. Dial (862) 434-1263 to talk with a local roofer about a coating.
Roof coatings are rolled or sprayed on as a liquid and cure into a continuous, flexible skin. It seals hairline cracks, covers seams and fasteners and protects the roof underneath from sun, which is what breaks most roofing down over time. A reflective white finish lowers roof surface temperatures, which helps rooms right under the roof.
The best candidates are flat and low-slope roofs plus metal roofs. Common substrates include rubber and TPO membranes, torch-down or self-adhered mod bit, built-up roofs, foam and metal panels. Most roofers do not recommend coating asphalt shingles, since it can trap moisture and may conflict with the shingle maker's terms.
The biggest mistake is coating a roof that is wet inside. If insulation or decking below the membrane is soaked, the coating seals the moisture in and the roof keeps deteriorating out of sight. Expect the roofer to test for moisture before recommending a coating at all.
Depending on what the roofer finds, roof coating in Haledon, NJ can go hand in hand with flat roof repair and metal roof coating.
Need roof coating in Haledon? Call (862) 434-1263 to reach a nearby roofing contractor.
Call nowMost of a coating job is preparation, not spraying.
The roofer checks the roof with a moisture meter, an infrared scan at dusk or small core cuts to find wet areas. Any soaked areas must be removed and replaced first.
The roof is washed to remove dirt, chalking, oils and loose material so the coating can bond. Metal roofs get rust treated, and some membranes need a specific cleaner.
Open seams, blisters, splits and failed flashing are repaired, and exposed fasteners on metal are tightened or replaced with oversized screws. Problems not fixed now will be buried under the coating.
Some substrates need a primer, and an adhesion test on a small area confirms the product will bond. Skipping primer is a common cause of peeling.
The crew builds up the coating to the specified thickness, measured in mils, across the whole roof. Thickness matters more than the number of coats.
Cleaning and rust treatment so the coating bonds properly.
A check for wet insulation or decking so the coating is not sealing in a problem.
Damaged areas fixed and reinforced with fabric at weak points.
A seamless coating sprayed or rolled over the roof with detail coats at seams and penetrations.
Roof restoration is a broader job than a simple coating: it brings a weathered roof back to good working order without tearing it off. A typical restoration combines wet-area replacement, seam and flashing repair, fastener work and a full coating system. It is a way to extend roof life while keeping the old roof out of the landfill.
Restoration only works while most of the roof is still dry and attached. Roofs that still feel firm underfoot and test mostly dry are the ones that restore well. A Haledon roofer should be able to explain clearly why your roof qualifies for restoration.
Flat roof coating is the most common use of roof coatings, since low-slope roofs face the most sun and standing water. Silicone handles ponding water well and stays flexible, acrylic is reflective and easy to recoat but should not sit under standing water, and polyurethane is tough against foot traffic and impact. The coating is matched to the existing membrane, so EPDM, TPO, mod bit and built-up roofs each have their own primers and products.
Before coating a flat roof, the drains and scuppers deserve a close look. Persistent ponding wears down coatings, so the roofer may add crickets or clear drains first. Regular inspection and an eventual recoat keep the roof protected.
In Haledon, the roofs that get coated are mostly low-slope membranes and metal panels, not shingle roofs. From Haledon out to neighboring communities such as Paterson, Hawthorne, Totowa and Glen Rock, coatings help weathered metal and rubber roofs on homes, barns and garages, but only when the roof underneath is sound.
Searching for roof coating near me from Haledon or Paterson, Hawthorne, Totowa and Glen Rock? Call (862) 434-1263 to talk to a roofer who works in your part of town.
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Haledon is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Haledon know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (862) 434-1263
Flat roof repairs matched to the membrane, whether EPDM, TPO, PVC, modified bitumen or built-up, with the patch made from material that bonds to what is there.
Learn moreElastomeric and silicone coating systems that renew an aging metal roof, on homes, shops and barns.
Learn moreSilicone, acrylic and other elastomeric coatings for commercial roofs, applied after repairs and cleaning.
Learn moreSeasonal roof maintenance for shingles, flashing, vents, gutters and attic airflow, before debris, wear and weather add up.
Learn moreLooking for something else?
See all roofing servicesCall (862) 434-1263 to talk to a roofer serving Haledon, NJ.