New panels
Fresh metal cut to length for each slope replace the old roof.
A roofer in Haledon can replace a metal roof that has rusted through, lost its finish or been riddled with worn screw holes, down to the purlins or deck, and help you decide between a tear-off, a re-cover or new panels in just the bad sections. Dial (862) 434-1263 to talk with a local roofer about replacing the roof.
A metal roof needs replacing when the metal itself is failing, not just the screws. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Thin panels from decades past are usually the first to rust through.
There are a few ways to replace a metal roof, and the right one depends on what is underneath. Stripping the old metal exposes the framing, which matters because fasteners in rotten wood will not hold. Retrofit re-covers add a new metal roof over the old one, attached through to the structure.
A big share of metal replacement work is switching a worn shingle roof to metal. That job can be a full tear-off or, where code allows, metal laid over one layer of shingles. Before calling, note the roof age, the type of panels or shingles on it and where it leaks.
Metal Roof Replacement is often paired with metal roof installation and metal roof repair, depending on the cause.
Dealing with this in Haledon, NJ right now? Call (862) 434-1263 to talk to a local roofer.
Call nowA metal roof replacement is planned around what is under the old roof.
The roofer counts rust-through spots, checks the finish and inspects the purlins or decking from inside the attic or building. It also tells whether the framing needs work first.
Tear-off, re-cover or metal over shingles is chosen, along with the new panel system, gauge and finish. Moving from purlins to standing seam often calls for a full deck.
Panels and trim come off section by section and go to a metal recycler. Sections are opened only when they can be dried in that day.
Rotten purlins are replaced, loose ones refastened and soft decking cut out and renewed. Sound framing is what keeps the new roof fastened.
New underlayment, eave trim, panels, ridge cap and flashing complete the replacement. Gutters may be reset to match the new eave line.
Fresh metal cut to length for each slope replace the old roof.
Rotten purlins and soft decking are replaced so fasteners hold.
New panels can be installed over existing metal on larger buildings.
The worn roof is stripped down to the framing and taken for recycling.
All new eave, rake, ridge and wall trim in the same finish as the panels.
When only a few panels are rusted through or torn, metal roof panel replacement can keep the rest of the roof in service. The damaged panel is unscrewed, the laps on either side are freed and a new panel of the same profile is lapped in and fastened. Concealed fastener panels take more time to replace because of the seams.
For a Haledon building with one or two bad panels, panel replacement is often the sensible step. The new panels may look brighter until they weather. Too many swaps, and a full reroof is the smarter route.
Metal over shingles is a common way to switch to metal without stripping the old roof. Battens or a new underlayment layer go over the shingles, then the metal is fastened into the decking below.
The catch is that the decking stays hidden. Before going over shingles on a Haledon home, the deck is checked from inside and any soft areas are found. If the deck is questionable or there are already two layers, a tear-off is the better choice.
Around Haledon, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. Older outbuildings in Haledon and nearby towns like Paterson, Hawthorne, Totowa and Glen Rock often have thin exposed fastener panels from decades ago, while homes are more often switching from worn shingles to metal, and the right approach depends on what the old roof is hiding.
Need metal roof replacement around Haledon? Call (862) 434-1263 for a Haledon roofer who serves the towns around it too.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Haledon, NJ have the roof checked in the fall and again after the snow melts.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Haledon know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (862) 434-1263
Metal roof installation built around the right panel, finish and trim for the house, with high-temperature underlayment and proper flashing.
Learn moreReplacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, so the panels keep shedding water for years more.
Learn moreReplacing an aging roof with new underlayment, flashing, vents and roofing, with the old layers removed and the deck checked.
Learn moreLong-lasting standing seam roofs, from snap-lock to mechanically seamed panels, with matching trim, closures and snow guards.
Learn moreLooking for something else?
See all roofing servicesCall (862) 434-1263 to talk to a roofer serving Haledon, NJ.